Results 1 to 12 of 12
Thread: follow your dreams
-
05-22-2014, 10:13 AM #1
follow your dreams
A 27psi run against the beast.
Went to a new spot for runs and no one there for me to run. Some mid 140 plus cars and then 120 and lower cars. So I did a fun run with my buddys beast nitrous cam c5z.
Blew off tires in 3rd he spun a bit too. I think with some sticky tires I'll be right there. But I also think that may end my auto Trans if I dead hook lol. I'll keep spinning for now lol
Enjoy
- Proven Power Tampa built 6466 ST -
- N54 6AT WR 711whp 637wtq-
-N54 WR 1/4mile trap: 133.57mph- -
-
05-22-2014, 10:56 PM #2Member
- Join Date
- May 2013
- Posts
- 2,950
- Rep Points
- 992.0
- Mentioned
- 58 Post(s)
- Rep Power
- 10
looks like it was a good run, nice!
2013 Audi S6 stock but shopping....
2014 RAM 2500 6.7 Cummins. Far from stock
-
05-23-2014, 12:46 PM #3
Fly by vid?
BRAND NEW IN BOX 991.2 standard/non-pse SPW cat bypass pipe for sale - $899 shipped
New generic 991.2 PSE bypass pipes - $499 shipped
-
05-23-2014, 01:02 PM #4
-
05-23-2014, 01:42 PM #5
Not bad though, it wasn't a total massacre.
Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
-
05-23-2014, 01:43 PM #6
yea i think on 27psi i have enough if i leave that hard without spinning. wouldnt best him but should be doors with traction
he is a "138" car. i ran some 140 plus cars on 30psi so traction is my biggest issue . but tranny may die if i dead hook . its a balance game for now- Proven Power Tampa built 6466 ST -
- N54 6AT WR 711whp 637wtq-
-N54 WR 1/4mile trap: 133.57mph- -
-
05-23-2014, 01:47 PM #7Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
-
05-23-2014, 01:47 PM #8
-
05-23-2014, 01:48 PM #9
-
05-23-2014, 01:49 PM #10
i wanna dyno 750 plus on a dynojet on the auto b4 i get rid of it for the lolz
- Proven Power Tampa built 6466 ST -
- N54 6AT WR 711whp 637wtq-
-N54 WR 1/4mile trap: 133.57mph- -
-
05-23-2014, 02:00 PM #11Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
-
05-23-2014, 02:25 PM #12
f30n55, we...
f30n55 is now here!