Results 1 to 3 of 3
Thread: Brake Related Hardware
-
11-17-2013, 09:10 AM #1
Brake Related Hardware
I'm installing the new brake related items below.
- Rotors (StopTech Sport Slotted Cyro-Treated)
- Pads (Akebono Euro Ceramic)
- Lines (Goodridge G-Stop)
- Sensors (OEM)
Is it advised to also install new hardware below? I found pad and rotor installation kits from ECS that use OE or OEM parts, but I want some opinions if it's needed, or more likely a waste.
- Anti-rattle clip
- Sensor clip
- Guide bushing set
- Caliper guide bolt
- Brake rotor set screw
- Collar screw
- Protection plates
(I'm currently at 55K miles)
-
11-17-2013, 09:59 AM #2
I replaced my pads and rotors around the same time. I did not replace any of the hardware listed. You should remove the guide pins and clean then lubricate them with grease meant for brakes. Permatex makes a ceramic grease available in small packets at your local auto parts store. I also used CRC Brake Quiet on the backs of the pads. My brakes make no noise. I used Hawk HPS pads.
Eppur si muove.
-
11-28-2013, 03:02 PM #3BRAND NEW IN BOX 991.2 standard/non-pse SPW cat bypass pipe for sale - $899 shipped
New generic 991.2 PSE bypass pipes - $499 shipped
Welcome...
NOOOOB: Rick1234