Brake Related Hardware

[RoyalFlush]

I'm installing the new brake related items below.

- Rotors (StopTech Sport Slotted Cyro-Treated)
- Pads (Akebono Euro Ceramic)
- Lines (Goodridge G-Stop)
- Sensors (OEM)

Is it advised to also install new hardware below? I found pad and rotor installation kits from ECS that use OE or OEM parts, but I want some opinions if it's needed, or more likely a waste.

- Anti-rattle clip
- Sensor clip
- Guide bushing set
- Caliper guide bolt
- Brake rotor set screw
- Collar screw
- Protection plates

(I'm currently at 55K miles)

[ajm8127]

I replaced my pads and rotors around the same time. I did not replace any of the hardware listed. You should remove the guide pins and clean then lubricate them with grease meant for brakes. Permatex makes a ceramic grease available in small packets at your local auto parts store. I also used CRC Brake Quiet on the backs of the pads. My brakes make no noise. I used Hawk HPS pads.

[Sticky]

@alex@ABRhouston